Reinzosil Victor Reinz Grey Silicone Sealant Gasket Gum (70ml)

Victor Reinz Gasket Sealant Reinzosil Gasket Gum (70ml)

Description:-
Solvent-free, permanently elastic, quick-hardening silicone compound for sealing flat surfaces with a sealing gap (without even requiring component disassembly).

Properties:-
– Wide temperature range from -50°C up to +300°C (short-term peak temperature)
– Excellent media resistance against gasoline and diesel fuels, oils, grease, lubricants, water, seawater, sunlight and ozone

Application:-
Especially for sealing all joints in engines, gear boxes, drive axles, cylinder liners and plastic housings. Excellently suited for rough sealing surfaces. Universally applicable for all engine and vehicle manufacturers.

Instructions for use:-
1. Remove any gasket remnants or other residues such as grease, oil, etc. with RE-MOVE solvent remover.
2. Allow the surfaces to dry, then apply the sealing compound on one side manually or by means of a pneumatic
spraying device.
3. Assemble the components immediately.
4. Processing temperature lies between +5 °C and +40 °C. Depending on temperature and humidity, a skin develops after 5 to 12 minutes. The full curing time depends mainly on the relative air humidity (RH) and room temperature, as well as on the thickness (gap height) and width of the applied layer.

The following applies:-
The higher that air humidity and temperature are, or the thinner and narrower the sealing layer is, the shorter will the curing time be. With a layer or gap width of e.g. 7 mm, and a thickness or gap height of 1,5 mm at 40 °C and 90 % RH, the full curing time is about 9 hours, provided that temperature and humidity have access to both sides. With the above sealing gap dimensions, but at normal ambient conditions.